Creo 教學專區 > Creo Simulate 教學專區 > 初學者教學專區 > Introduction to PTC Creo Simulate Lite > Exercise2—Reviewing Analyses Results > Creating Capping Surfaces
  
Creating Capping Surfaces
A capping surface is a plane that slices your model and trims either the top or bottom away. You can only define one capping surface for your model.
You can use the capping surface to get a better understanding of the analysis results inside a model.
1. Click View > New. The Results Surface Definition dialog box opens.
2. In the Type box, select Capping surface.
3. Set Location to Below and click Apply.
4. Click Dynamic.
5. Click in Window2 and drag the pointer to change the position of the section.
6. Right-click to exit dynamic dragging.
7. Click OK to close the Results Surface Definition dialog box.