要修改平行剖面线的偏移
使用“偏移”(Offset) 命令可更改平行类型剖面线第二条线的偏移。
1. 单击
![](../../../optm/options_modeler/images/search16x16.png)
。在
![](../../../optm/options_modeler/images/search16x16.png)
旁边将出现一个框。
2. 在框中键入“剖面线编辑器”(Hatch Editor)。“剖面线编辑器”(Hatch Editor) 对话框随即打开。
3. 单击
“剖面线编辑器”(Hatch Editor) 对话框中的
![](../../../optm/options_modeler/images/open16x16.png)
并浏览至要编辑的图案 (
.xch 文件)。选定图案会显示在
“剖面线编辑器”(Hatch Editor) 对话框中。
4. 使用
![](../../../optm/options_modeler/images/next_window16x16.png)
或
![](../../../optm/options_modeler/images/previous_window16x16.png)
选择要编辑的直线。
5. 在“偏移”(Offset) 框中,指定直线的移动距离,然后按 ENTER 键。系统会相对于零位置测量偏移。
6. 单击
![](../../../optm/options_modeler/images/save16x16.png)
将更新的图案保存到
.xch 文件。