Route cables manually by spline
With the Spline command, you can select points in the viewport along which the cabling follows a smooth curve.
To manually route cabling in spline segments,
1. Click
Cabling and then, in the
Manual Routing group, click
Wire.
2. Click
Spline Wire. The
Create Cable dialog box opens.
4. Click a point in the viewport to start the cable.
◦ Click Dynamic to use the 3D Copilot.
5. Select a method in the Modification by 3D CoPilot section of the dialog. You can switch between these two methods as you route your cable:
◦ Click Adding to add an additional cable segment each time you select a point in the viewport.
◦ Click Moving to move the most recently created cable segment.
6. Continue routing the cable by clicking further points in the viewport or with the 3D Copilot.
7. Click
to complete the operation.